Hi Guys,
First post here be kind.

I had a problem with my CNC where the VFD appeared to have died so I purchased a AT1 0.75Kw single phase to three phase VFD off Ebay.

I have a problem, I think it is configured to operate correctly with my Perske VS 31.09.2 but when I try to run it I get an error where it starts to turn but then trips showing fault ERR 1 Short Circuit/Current overload/ Power Module Protection.

Is there something I have set wrong or is there a fault with the spindle or VFD.

I really would appreciate any assistance you can offer.

Many Thanks in advance.