Threaded View
-
14-11-2021 #2
Last Activity: 1 Week Ago
Steppers draw full current at idle.
Unless you have a driver that reduces current at idle and that function is enabled.
Are you sure you have the current settings correct?
What driver?
What voltage?
Have you measured the temperature?
Steppers can run hot, over 80c without issue.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Y axis problems
By Desertboy in forum General DiscussionReplies: 2Last Post: 22-12-2019, 11:04 PM -
Again Pokeys57CNC problems, anyone using it?
By Boyan Silyavski in forum PoLabs (PoKeys)Replies: 31Last Post: 13-09-2019, 05:35 PM -
CNC problems
By martythunder in forum General DiscussionReplies: 1Last Post: 15-02-2017, 08:10 PM -
Mach3 Problems problems problems.
By ECCO in forum Artsoft Mach (3 & 4)Replies: 18Last Post: 09-07-2016, 10:07 AM -
NEW MEMBER: MDF Problems
By MrWiz73 in forum New Member IntroductionsReplies: 4Last Post: 31-12-2011, 12:39 AM
Bookmarks