-
08-07-2023 #1
Last Activity: 23-10-2023
Does anyone know the UC300 "Digital Dream" controller card by Novusun? For each axis, it has Pulse +/- and Dir +/-, no 5V output. The stepper drives that I have only takes a 5v input and step and dir (see attached image). Is it possible to wire these drives to the controller?
Many thanks 🙏.
-
08-07-2023 #2
Last Activity: 2 Days Ago
It should work if you provide 5V to the drive + pin (5V needs to have a shared gnd with the controller), then only connect the step/dir - outputs to the drive Step/dir inputs.
Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
08-07-2023 #3
Last Activity: 23-10-2023
Guess I'll need to get a 5v supply because there is nothing on the controller :(.
Thanks for the reply!
-
08-07-2023 #4
Last Activity: 2 Days Ago
Check the COM+ pin for 5V
Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
09-07-2023 #5
Last Activity: 1 Day Ago
If you need a 5 supply then a USB wall wart is a quick and cheap solution - old phone charger.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: Steppers,drivers.etc,etc.
By molliemilo1 in forum Items For SaleReplies: 2Last Post: 18-10-2019, 08:57 AM -
Uc300 motion controller problems
By Hellfire in forum CNCdrive (UCCNC)Replies: 2Last Post: 07-11-2016, 07:21 PM -
Help wiring M60STH88-3008DF Steppers Motors to 752 Drivers
By Mad Professor in forum Stepper & Servo MotorsReplies: 12Last Post: 01-09-2011, 10:09 AM -
Has anyone used these steppers or drivers?
By Jonathan in forum Stepper & Servo MotorsReplies: 2Last Post: 24-03-2011, 02:24 PM -
Steppers and drivers
By Davidh in forum Motor Drivers & ControllersReplies: 3Last Post: 12-06-2009, 05:59 PM
Bookmarks