Thread: TB6560 > Timer > GMFC
-
17-10-2010 #1
Although there are more threads about the TB6560, I would like this thread into a clear solution how the configuration should look to get it work.
There are people claiming with the timer from the GMFC site have everything work but unfortunately not explain further. I understand that some parallel port pins have to be swapped.
The timer is very easy to build. The diagram shows the designated ports. But there is no in and out? How to place this timer between the TB6560 and the computer??
Need some help here!!!!
pin TB6560--------------- pin GMFC
2 spindle------------------
4 X enable----------------
1 X dir--------------------2 X dir
16 X step-----------------9 X step
17 Y enable--------------
7 Y dir-------------------4 Y dir
14 Y step-----------------7 Y step
5 Z enable----------------
6 Z dir --------------------6 Z dir
3 Z step-------------------5 Z step
5 C enable----------------
8 C dir-------------------- 8 C dir
9 C step-------------------3 C step
Last edited by Theo; 17-10-2010 at 07:52 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
tb6560
By uppy121 in forum Motor Drivers & ControllersReplies: 7Last Post: 08-04-2013, 10:39 AM -
1 axis tb6560 any good?
By lazzymonk in forum Motor Drivers & ControllersReplies: 15Last Post: 08-08-2012, 07:58 AM -
Who knows this updated chips than TB6560?
By Christina in forum Motor Drivers & ControllersReplies: 0Last Post: 25-11-2011, 08:26 AM -
TB6560 Motor Match
By Telly in forum Motor Drivers & ControllersReplies: 10Last Post: 22-02-2011, 06:29 PM -
NEW MEMBER: Old timer, still learning, Virginia, USA
By GerryR in forum New Member IntroductionsReplies: 1Last Post: 13-10-2010, 10:41 PM
Bookmarks