Threaded View
-
09-07-2013 #6
I'm guessing we're talking loads here? it's a rather non-standard application with a z-axis alone, nothing else, as I need precision positioning in the vertical. Max loads would be maybe 1-5% of the maximum load capacity of the ball screw given to me by Chai (quoted figures where 4kN for static load and 3.5kN for dynamic load). The Z-axis runs on 15mm Hiwin rails, which are a pain in the ass to use, as their profiles are super low, which is why I've got this depth problem.
Regards,
dsc.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plasma floating head...
By Davek0974 in forum Plasma Table MachinesReplies: 27Last Post: 01-01-2015, 01:52 PM -
advice on floating bearing - outer ting rotating
By dsc in forum Lead Screws, Nuts & SupportsReplies: 8Last Post: 18-11-2013, 02:23 PM -
non-locating / floating bearing - shaft location
By dsc in forum Linear & Rotary MotionReplies: 5Last Post: 28-06-2013, 10:07 PM -
Driving floating end (ballscrew)
By blackburn mark in forum Lead Screws, Nuts & SupportsReplies: 16Last Post: 11-09-2010, 11:55 AM -
Looking for a housing for your electronics?
By Smiler in forum Electronic Project BuildingReplies: 1Last Post: 01-09-2008, 07:38 PM
Bookmarks