Threaded View
-
20-04-2015 #1
Having trouble after having to change PC.
Was running Mach 3 (demo) on a HP PC which has now died and have installed mach3 on a dell optiiplex 740 (the only other machine I had with rs232 interface. Running 32 bit windows 7 (old one had XP on) using it with routout interface.
Have copied my sherline.XML profile across but not having any luck getting it to run.
The z axis will jog and it will go to zero but x&y are not doing anything.
I think I am going round in circles and missing something obvious.
I thought port and pins was in the sherline profile but am I mistaken. Are there any other files I should copy over to my mach3 folder?
I didn't set up the hardware etc myself originally it was purchased ready to run and so unfortunately this is almost a first time setup for me although I have been using it.
Have watched YouTube setup videos etc and read anything I can find about setting up but don't seem to be any further on.
Any help would be appreciated.
Thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to change breakout board
By GeoDurie in forum General ElectronicsReplies: 2Last Post: 23-07-2014, 07:44 AM -
Change of plans: basements
By Rogue in forum Workshop & EquipmentReplies: 22Last Post: 28-03-2013, 10:38 PM -
did you change something?
By wilfy in forum General DiscussionReplies: 4Last Post: 29-12-2012, 10:58 PM -
how to change a clip art
By luke11cnc in forum Computer SoftwareReplies: 6Last Post: 03-12-2011, 12:47 PM -
X2 change balls crews or not?
By Oldie45 in forum Sieg Milling MachinesReplies: 7Last Post: 17-08-2011, 07:55 PM
Bookmarks