Threaded View
-
28-10-2020 #2
Hate to reply because if you get a dud it looks bad. BUT... the Chinese water cooled spindles, and a Huanyang VFD are the staple for most builds here, and many a machine you'll find on the market. They're covered in Chinglish marketing speak (sometimes the claim of 4 German bearings is a little optimistic... sometimes not), but they generally work well. Nice a quiet, and usually low run-out on them. Cock all power below 6krpm, but above that they perform well.
I can't help but think, however, for the same cash (or less) you'll find a 2.2kW one - you claim you don't need the power, or the larger ER20 collet. Until you do.
They're a good buy. Provided they work :)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Any thoughts on this design for a gantry setup?
By Dwayne Dibbley in forum Machine DiscussionReplies: 8Last Post: 05-02-2015, 08:49 PM -
what are your immediate thoughts looking at this psu/ drives and bob in a box
By nobby in forum General ElectronicsReplies: 9Last Post: 21-02-2014, 09:57 PM -
Initial thoughts on new build
By Neale in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 25-01-2014, 11:05 PM -
Spindle chat and thoughts
By black5f in forum Spindles & Drive MotorsReplies: 4Last Post: 22-11-2011, 10:47 PM -
Any thoughts on pendants?
By Robin Hewitt in forum Machine DiscussionReplies: 5Last Post: 27-12-2009, 07:28 PM
Bookmarks