Missing information for Mach3 settings

[Doddy]

I don't know your board, but a Chinese NVEM controller specifies in the manual that the X/Y/Z/A/B/C ports are hard-coded in the driver and you don't need to specify them in Mach3 (defaults to port/pin 1/0). Try it and see.

[JAZZCNC]

I don't know your board, but a Chinese NVEM controller specifies in the manual that the X/Y/Z/A/B/C ports are hard-coded in the driver and you don't need to specify them in Mach3 (defaults to port/pin 1/0). Try it and see.

Doddy, where are you getting that he's using an NVEM controller from.? That picture is of a standard BOB.!

Regpye, this link is a better manual and may help, if you don't understand it just say so, and will talk you throw it.

https://www.steppermotorcanada.ca/bl5breakoutboard.pdf