Hybrid View
-
26-07-2021 #1
A quick scan looks OK.
However, what's with all the diodes?
On the input side, I could see sense in having LEDs for diagnostic purposes, but on the output/LPT side, they don't really serve much purpose.
Also, will the 5V on the LPT supply enough current for all the optos?
If you're worried about protecting the 5V, I'd think a 5.1V zener would provide more protection than a diode on every opto.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
26-07-2021 #2
Hopefully this is relevent.
A quick read of 300eth manual again.
The 5v is a pass through from my seperate psu which is supplying it.
Into the controller from my psu (using a 5v 3A) to power it's logics and passing through to pin 26 for powering additional I/O.
States :Minimum for controller = 500ma. Higher needed for adding extra I/O.
Have a UCBB under power from Pin26 on port 1+2 already for axis controls (16 outputs - 18 inputs).
All output pins TTL max 20ma. Inputs TTL 0/5v levels.
Took the 5v in diagram from Pin 26 on port 5 for convenience due to it being right next to opto board in the box layout.
Psu itself is further away.Last edited by dazp1976; 26-07-2021 at 11:31 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wiring Diagram check
By eurikain in forum Electronic Project BuildingReplies: 81Last Post: 08-12-2017, 08:40 PM -
Which wiring diagram software do you use ?
By eurikain in forum Computer SoftwareReplies: 3Last Post: 11-10-2015, 02:48 PM -
VFD Wiring Diagram
By Tomnewry in forum General ElectronicsReplies: 9Last Post: 14-10-2013, 06:46 PM -
Wiring diagram for 4x4 cnc router
By Danielroyal25 in forum General ElectronicsReplies: 1Last Post: 19-07-2013, 11:14 PM -
NEW MEMBER: Hi, Looking for a wiring diagram, Melbourne
By Sampop in forum New Member IntroductionsReplies: 1Last Post: 28-10-2010, 11:18 AM
Bookmarks