Threaded View
-
27-05-2017 #11
New spindle arrived already... looks/sounds good spinning up, but as per camera's experience it wasn't earthed at all.
Swapped over the connector while I was at it, added an earth and made sure I had continuity to the main body too.
Fingers crossed the spindle was actually the problem!
Thread Information
Users Browsing this Thread
There are currently 13 users browsing this thread. (0 members and 13 guests)
Similar Threads
-
Initial design advise wanted
By driftspin in forum Gantry/Router Machines & BuildingReplies: 45Last Post: 24-10-2017, 06:55 PM -
Initial Design Check Please
By Gotty101 in forum Gantry/Router Machines & BuildingReplies: 90Last Post: 28-02-2017, 07:53 PM -
Critique required on y-axis design.
By Spedley in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 06-05-2013, 09:17 PM -
About to build CNC miller, need design critique please
By JW149 in forum Milling Machines, Builds & ConversionsReplies: 8Last Post: 23-04-2012, 09:28 PM -
NEW MEMBER: About to build CNC miller, need design critique please
By JW149 in forum New Member IntroductionsReplies: 1Last Post: 22-04-2012, 07:01 PM
Bookmarks