Thread: CNC 6040z USB z-axis
Threaded View
-
22-03-2018 #1
First Post and looking for help.
I am prepared to look foolish! We have purchased a CNC6040z USB interface from China. All went well during the install process and script changes in the mach3 software provided.
However, when we attempt to control the z-axis regardless of instruction within the software, the direction of travel is always down. I have tried swapping the Y and Z connector at which point the fault moves to the Y-axis and the Z is correct.
I was assuming this was a hardware fault with the controller but was wondering if anyone had seen a similar fault and found it to be software?
Many thanks in advance for any help.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
6040Z USB CNC - USB port not recognised.
By Roy in forum Chinese MachinesReplies: 9Last Post: 23-05-2021, 10:04 AM -
B Axis indexing and easy workflow for repetitive cuts 4-axis
By deemoss in forum General DiscussionReplies: 1Last Post: 21-06-2017, 12:34 PM -
Engraving small font - the bit digs deeper and deeper as the job goes on. 6040z
By xoneeleven in forum Chinese MachinesReplies: 46Last Post: 26-04-2016, 12:06 AM -
NEW MEMBER: Goal - Enable 3-Axis CNC Bed Mill to Perform 5-Axis Milling
By LoveLearn in forum New Member IntroductionsReplies: 2Last Post: 25-01-2012, 08:46 PM -
Precision metal processing (3 axis, 5 axis, 7 axis) OEM
By 7AxisCNC in forum Manufacturer NewsReplies: 0Last Post: 17-05-2011, 02:04 PM
Bookmarks