Threaded View
-
16-08-2012 #1
Last Activity: 24-11-2014
Hi All
Not sure if this is the right section for this, but here goes.
I now have my Stepper motors & Drivers, a Breakout Board and PSU. My question is this - What size/gauge wires do I need to connect these items (The Motors are already wired). Can anyone supply I good hard wire schematic I could use. I appreciate I need a panel mounted E Stop & On/Off switch, but do I need to put in extra fuses, in the control (240vac) circuit?
Regards
Ray
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Breakout Board
By Tomnewry in forum General ElectronicsReplies: 2Last Post: 12-12-2013, 07:24 PM -
Breakout Board Comparison
By 200thhorseman in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 27-03-2012, 12:28 AM -
Breakout Board
By croy in forum Electronic Project BuildingReplies: 10Last Post: 18-08-2011, 07:50 AM -
FOR SALE: 4 Axis TB6560 Stepper Motor Driver Board
By Mad Professor in forum Items For SaleReplies: 1Last Post: 04-01-2011, 06:54 PM -
eBay: CNC Breakout board cheap - that will do me !
By Lee Roberts in forum Items On eBay UKReplies: 9Last Post: 14-08-2009, 05:52 PM
Bookmarks