Activity Stream

Easiest option is to start disconnecting things. Are there any internal fuses that you could start by disconnecting? Also, it would be good if...

I suspect that one reason is that this is a commercially-built machine and not many forum members are familiar with it. I have absolutely no idea...

Im also in Havant, I work in IT and have lots of Pc Spares if you need anything, including lots of old Dell towers etc. Let me know, id be interested...

Right I will have a play with that bud , yes I did notice the lack of input ������

Thats not too bad,is it what you were expecting?I'm guessing you did a tool change and there may be a very slight discrepancy in the tool length for...

This what happened tonight

How about a screenshot of the Vcarve simulation?Come to that,have you tried asking for help on the Vectric forum?You have arrived at the point where...

Sorry for the bad piece of wood but it's only testing. This is how it comes out in the finishing, I have tried it out from two computers that...

I'd be taking a look at the parameters for the finishing cut.It might be that the stepover settings for the tool need to be reduced to a much smaller...

Apologies that this video series might not mean much to people without solar, or with AC coupled systems, but for hybrid inverters it not possible to...

Everything is working as it should......Except if I send a 3d relief to the machine, the roughing process is done as it should but when I upload the...

Cheers bud

That wold be my choice of post processor too.Check the tool parameters perhaps.The other thing might be to use "Vector Validator" to see if any...

Any idea what post processer that should be used with this machine I have it on AXYZ Arcs mm *nc just now and carver a flourish , the roughing...

You are welcome.

Hi Bud The switch on the back of the head has three settings. Auto.Hand. and off , I will have a look on vcarve Pro. I will have a look on the...

I know nothing about suds,there might be a setting in Vcarve that would activate it if there isn't a tap.Are you sure it isn't an autolube system? ...

Welcome bud Hope you find this site useful and post your projects for all to see

Exactly Routerdriver Small steps, one at a time, But two things that baffles me is how do you get the suds working, the pot on top of the machine...

Good to know it worked out.Make haste slowly and be careful when working with material of a different thickness.

Bingo and just like that , it's all working perfectly. Write the program what I want in v,carve Pro and send it across. Perfect. Just took...

Thanks for the offer Andy. I don't even know what UCCNC is, lol, I'm guessing it's a controller software of some sort. That's how green I am. I...

Thanks for the reply Neale. I still have the install file on my everyday PC, so that's not a problem, I also don't have the licence key anymore. I...

PM Sent

If I was in the UK, I would grab this quickly Raj, but sadly shipping it down under would be prohibitive.