Activity Stream

Hope you will have a better new year and hopefully your new nee holds up. Best wishes Clive

Merry Christmas everyone and all the best for next year :beer: I was gifted a total right knee replacement in July this year, like the last one,...

It's going to be very dependant on your machine. If you have a low powered spindle, it seems it will stall before snapping. Presumably on such a...

The right answer is obviously to fit the tool changer with a home switch so that Mach3 can properly initialise it when you first start - the only way...

Well, I'm still bemused. If it's the cutter that stalls the spindle then it has to take all the momentum of the spindle to stop it so the...

Cutting 1000 grade thin sheet tend to gum up the cutter. It’s almost pure aluminium. Then it stops cutting and the spindle stalls and the end mill...

Hi John no, if the indexer is in the wrong position, then when I type in the tool number, it goes to the tool it thinks is the one you enter... ...

Not sure of your question, but don't you just type the current tool number into the appropriate DRO?

I'm a bit bemused by this. In my experience of breaking cutters the spindle has never stalled, if it had the cutter might not have broken! The last...