CrazeUK
28-02-2017, 03:53 AM
Hey Guys.
So a few things..
I noticed my machine had extrusions which where double mounted to make them far taller than needs be.
So today i have taken the extensions off, leaving me with a frame i cant attach to the MDF board.
I presume Sliding nuts / t slots would be fine if i made approximately 5 holes on either side of the 1 meter x 1 meter board?
So having looked at the various types of nuts, i cant seem to work out the extrusion type/series.
The rails i have are 20mm x 80mm.
How can you tell the major differences1?
1
So a few things..
I noticed my machine had extrusions which where double mounted to make them far taller than needs be.
So today i have taken the extensions off, leaving me with a frame i cant attach to the MDF board.
I presume Sliding nuts / t slots would be fine if i made approximately 5 holes on either side of the 1 meter x 1 meter board?
So having looked at the various types of nuts, i cant seem to work out the extrusion type/series.
The rails i have are 20mm x 80mm.
How can you tell the major differences1?
1