Brett
29-03-2019, 04:32 PM
Hi all, im a new member and new to CNC machining, im looking to get a project prototyped and was woundering were is a good and cheap place to have it done, its a stand for my Stereo Microscope that uses Linear Bearings, note that you can buy this stand for about £280-350 and as you may have guessed I don't have that right now, I have had quotes to make it @£120 per part and there is 4 parts total all made in aluminium, has 3mm, 16mm, 28mm and 32mm holes mostley straight through, I will show a pic of one(the most complex one) below, what would you do to get it made ?
Also it can be edited eg : remove the rounded edges and small holes that I can do at home.
Thanks all for your input
Brett
Also it can be edited eg : remove the rounded edges and small holes that I can do at home.
Thanks all for your input
Brett