Desertboy
15-02-2020, 08:30 PM
How do I do a manual toolchange and then set the height?
I think I need to add Manual NC before the toolpath
27404
What does "Force manual tool change" do on the DDSCV?
What I would like is it to G28 and move it to a safe position
Release control so I can probe after toolchange to set Z.
Then press start to resume
How does it actually work?
I have it setup as a Fanuc, what other processors work in Fusion 360?
Thanks
I think I need to add Manual NC before the toolpath
27404
What does "Force manual tool change" do on the DDSCV?
What I would like is it to G28 and move it to a safe position
Release control so I can probe after toolchange to set Z.
Then press start to resume
How does it actually work?
I have it setup as a Fanuc, what other processors work in Fusion 360?
Thanks