View Full Version : FOR SALE: Steppers (3), Drives (3), Breakout board and 500w 48v PSU
deannos
10-10-2012, 05:11 PM
for sale due to change in plans and time, were only used for a couple of hours
3 X Stepper motors - 3Nm, double shaft (low inductance) (M60STH88-3008DF)
3 X Microstepping Drives - 50VDC, 4.2A (MSD542)
Parallel port breakout board
48v / 500W PSU
Looking for £180 ono including postage
JoeHarris
10-10-2012, 07:10 PM
Would you be willing to split them up?
deannos
10-10-2012, 07:30 PM
Would you be willing to split them up?
I would really like to sell them as a complete set.
audioandy
10-10-2012, 09:30 PM
You have PM
Jonathan
11-10-2012, 12:00 AM
Looks like I'm too late here. If you are willing to split I'd like then I reserve the 3 stepper motors :tongue:
audioandy
11-10-2012, 07:12 AM
Still waiting for a reply to my PM Jon I've told Dennos I'm Interested in the lot
irving2008
11-10-2012, 07:49 AM
Too late guys, I was there before you :applouse: (by about 2 hours ) but still waiting on a reply as well...
deannos
11-10-2012, 08:32 AM
Sorry about not replying but had a long day and hit the sack just after posting. I have replied to the pm's as well
Dean
irving2008
11-10-2012, 09:02 AM
Sorry about not replying but had a long day and hit the sack just after posting. I have replied to the pm's as well
Dean
No probs :biggrin:
audioandy
11-10-2012, 09:03 AM
Hi Dean
My PM has not been replied to from last night
Andy
deannos
11-10-2012, 09:16 AM
Hi Dean
My PM has not been replied to from last night
Andy
Sorry Andy, i did write a reply but must of hit the wrong button, pm now sent
WandrinAndy
11-10-2012, 09:31 AM
Too late guys, I was there before you :applouse: (by about 2 hours ) but still waiting on a reply as well...
You sure have a nose for a bargain Irving.... I'm almost starting to think that you somehow get advance notification whenever there's one going ;-)
irving2008
11-10-2012, 09:55 AM
Sadly missed many more than I caught... almost missed this one, was off to bed and logged back in to check something and couldn't resist a quick peek at 'new posts'...
The new drivers/PSU will go on the MaxNC mill I bought, will be a performance upgrade and give me a bit more speed over the current 24v system, while the new steppers will be paired up with the 70v drivers I recently got and will go towards the bigger mill... when the workshop is built... or maybe the vertical router I have made space on the wall for :smile::smile:
Lee Roberts
11-10-2012, 10:44 AM
You sure have a nose for a bargain Irving.... I'm almost starting to think that you somehow get advance notification whenever there's one going ;-)
Best thing to do is setup an RSS Feed to the forum your most intrested in, depends what program you use for RSS as to how/what options you get but its really easy to do.
.Me
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.