View Full Version : Suggested Velocity and Acceleration Values for a Denford Mill
I have been very conservative with my Denford mill and my new servos but feel that the machine moves too slow when not cutting.
My motors spin at max 3000 rpm, my leadscrews are 5mm pitch with a gearing of 1.4:1 (roughly).
Any suggested max values for Velocity / Acceleration? What is reasonable?
Thanks
So I played around. At 3000mm/min, I get PID errors. I need to do more tuning on my motors but a lack of serial port, to run the software is a problem. Need to get that fixed first.
JAZZCNC
12-10-2015, 08:02 PM
Very hard to suggets settings Charl because every machine is different. It's just case of trial and error tweaking to suit your machine.
Very hard to suggets settings Charl because every machine is different. It's just case of trial and error tweaking to suit your machine.
Thanks.
Didnt expect 10K moves. 2K is nice already for free travel at least.
gasmeter
15-03-2016, 06:12 PM
Hi Chaz
Which Mill ? I have a quattro mill with heidenhain controller and my friend has one with a fanuc .
Regards
Peter
Hi Chaz
Which Mill ? I have a quattro mill with heidenhain controller and my friend has one with a fanuc .
Regards
Peter
My Triac VMC that has been retrofitted with newer servo motors etc.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.