Easy change collets

Hi, I would like to buy some easy change Collets for my denford novamill, If you have any please make me an offer.

Regards Morten

If it's the holders you need Coventry Engineering still supply them.
http://www.coveng.co.uk/group/covent...sy-change.html

I have also been on the look out but not found anything second hand.

This place sells them, not cheap though:-

http://www.engineeringsupplies.co.uk...75.html?menu=1

Do you already have a selection of easychange holders? If not, it may be a cheaper option to swap out the easychange system (sell it) for a standard ER32 holder and a selection of collets?

Another option would be just to buy a easychange ER32 collet chuck (~£80 on the above link) and a selection of collets?

Cheers,

Jim

Morgen, I have an Easychange bt30 holder with two ER16 collet chucks that fit it, off my Novamill. Would this be interesting? I use straight er16 chucks in my machine. I'd prefer to sell as a job lot, they don't get used.


Sent from my iPad using Tapatalk

JohnHaine, PM send.

Quote:

---

Originally Posted by cncJim

This place sells them, not cheap though:-
http://www.engineeringsupplies.co.uk...75.html?menu=1

---

Thanks for the reminder Jim!
My little mill came with a 6mm endmill holder and a 10mm endmill holder, I've been using ER11 collet chucks on 10mm straight shanks (about £7 each on ebay) for 0-7mm tool holding.
I've just ordered an extra 10mm holder and a 12mm holder for ER16 collet chucks on 12mm straight shanks (about £10 each on ebay) to expand the range of tooling I can use,
Regards,
- Nick

Quote:

---

Originally Posted by cncJim

I have also been on the look out but not found anything second hand.

This place sells them, not cheap though:-

http://www.engineeringsupplies.co.uk...75.html?menu=1

Do you already have a selection of easychange holders? If not, it may be a cheaper option to swap out the easychange system (sell it) for a standard ER32 holder and a selection of collets?

Another option would be just to buy a easychange ER32 collet chuck (~£80 on the above link) and a selection of collets?

Cheers,

Jim

---

Try here:-- http://www.jurassictools.com/store/s...se=easy+change

Quote:

---

Originally Posted by Storeman

Try here:-- http://www.jurassictools.com/store/s...se=easy+change

---

Good call! I've dealt extensively with Tony through eBay and have also used his website and have always been pleased with the quality and service,
Regards,
Nick

Quote:

---

Originally Posted by mortenl

Hi, I would like to buy some easy change Collets for my denford novamill, If you have any please make me an offer.

Regards Morten

---

I have quite a few, from a denford "Easimill", at least 6 I think. Let me know if you're interested and I'll check what sizes they are.