Easy change collets

[cncJim]

I have also been on the look out but not found anything second hand.

This place sells them, not cheap though:-

http://www.engineeringsupplies.co.uk...75.html?menu=1

Do you already have a selection of easychange holders? If not, it may be a cheaper option to swap out the easychange system (sell it) for a standard ER32 holder and a selection of collets?

Another option would be just to buy a easychange ER32 collet chuck (~£80 on the above link) and a selection of collets?

Cheers,

Jim

[magicniner]

This place sells them, not cheap though:-
http://www.engineeringsupplies.co.uk...75.html?menu=1

Thanks for the reminder Jim!
My little mill came with a 6mm endmill holder and a 10mm endmill holder, I've been using ER11 collet chucks on 10mm straight shanks (about £7 each on ebay) for 0-7mm tool holding.
I've just ordered an extra 10mm holder and a 12mm holder for ER16 collet chucks on 12mm straight shanks (about £10 each on ebay) to expand the range of tooling I can use,
Regards,
- Nick

[Storeman]

I have also been on the look out but not found anything second hand.

This place sells them, not cheap though:-

http://www.engineeringsupplies.co.uk...75.html?menu=1

Do you already have a selection of easychange holders? If not, it may be a cheaper option to swap out the easychange system (sell it) for a standard ER32 holder and a selection of collets?

Another option would be just to buy a easychange ER32 collet chuck (~£80 on the above link) and a selection of collets?

Cheers,

Jim

Try here:-- http://www.jurassictools.com/store/s...se=easy+change

[magicniner]

Try here:-- http://www.jurassictools.com/store/s...se=easy+change

Good call! I've dealt extensively with Tony through eBay and have also used his website and have always been pleased with the quality and service,
Regards,
Nick