Search:
Search: Search took 1.00 seconds; generated 78 minute(s) ago.
-
04-11-2022
Thread: Mini-DIN pinout for XINJE XDM-60T4-E
by Doddy- Replies
- 1
- Views
- 32,219
Re: Mini-DIN pinout for XINJE XDM-60T4-E
Have you seen http://www.imenista.com/pdf/XDXDM%20instruction%20manual.pdf page 288?
I have no experience, but seems to be a reasonable google-hit. -
16-10-2022
- Replies
- 1
- Views
- 9,645
Re: How to reverse overwriting the program in Inovance H3U?
Naprawdę nie wiem o tym, myślę, że powinieneś skontaktować się z Inovance i zapytać ich, w końcu to tylko szybki e-mail do wysłania lub telefon ?
Nie zapomnij dać nam znać, co mówią :)
... -
25-01-2022
Thread: Wiring between AXBB-E and Proma THC 150
by JAZZCNC- Replies
- 4
- Views
- 8,596
Re: Wiring between AXBB-E and Proma THC 150
Like this, I believe but have never used one so check it out.
30834 -
19-10-2021
- Replies
- 8
- Views
- 14,870
Re: Connection between AXBB-E and plasma torch by relay
As you know 24V is more common in commercial machines, and there will be an upper limit on the voltage the AXBB-E internal transistors can survive. 12V is more common in cheapskate machines that use...
-
18-10-2021
- Replies
- 8
- Views
- 14,870
Re: Connection between AXBB-E and plasma torch by relay
O1 is the charge pump and I believe it just draws that pin down to ground when it gets a signal from the PC. If it looses connection that pin is not active so it is designed to be used for system...
-
18-10-2021
- Replies
- 8
- Views
- 14,870
Re: Connection between AXBB-E and plasma torch by relay
Section 7 of the manual on page 18 says the 24V supply can be anything between 12 and 24V. 12V works fine as long as the connected devices are designed for it. It's what I use without any problems.
...
Results 1 to 6 of 6

DIY spindle stall monitor