Search:

I have a Fanuc based Cyclone with ATC, let me know if you have any questions.

I had a similar problem with my Triac, tried new pull studs but still had issues with of them. I removed the cylinder from the top of the drawbar and adjusted the screw in the end of the spindle...

Bright Mild Steel has not been polished, it refers to mild steel in its bright drawn form which is significantly straighter and flatter than hot rolled mild steel.

Not sure what it is called but I have purchsed some from these guys before......

If it is working as it is I would recommend keeping the Siemens control, I imagine there will be a solid closed loop servo system in there along with everything else that an industrial control...

Hi guys, Lee sorry I didn't reply to your message a while back. I didn't make the vice I sold, just sold it because I needed the money, but wished I had taken all dimensions so I could of copied it...

I recommend these machine paints, great colours and really nice finish if applied with a brush or spray...

http://www.stationaryengineparts.com/Workshop-Machinery-Colours/

They sell a good...

As someone has said above, an M0 is the best way to pause the program.

An example would be...
(this is based on fanuc/has g code but the format will be the same)

...
G83 Z-10 R3. Q3. G99...

I would definately recommend a 1 or 2 flute cutter with a slow spiral, your 4 flute cutter doesnt leave much chip clearance. I would rough first then use the 0.8mm left to finish both sides, very...