Search:

Hi Bush flyer,

I recently cut some elongated slots with a 3mm carbide bit without any problems. I don't use the 3mm cutter much (tend to use 6mm) so haven't experimented but the following...

Yes, I asked what other software was running earlier.
And this is the best place to know what services etc. you can safely get rid of, this is Windows 32bit but there's all the others there too.
...

Ok this needs explaining better.? When you say the G-code Stops plus Machine then it carrys on do you mean it pause's for a second then continues.?

If so then this is indicates a computer problem...

Yes


Yes


Yes


Yes if the diameter is sensible to do so.

Additionally, since we know that 3-phase power transmission is more efficient than single phase, that shows we can use a bit less than 1mm^2 cable from the inverter to the spindle. However the cost...

I have used cy cable 1mm 4 core from the inverter to the spindle, 3 cores are for driving the spindle and the fourth core is to earth (my spindle has a 4 pin socket on it) on mine pin 4 was not...

Cooling requirements greatly depend on how much power you draw from the spindle, but in general people use these spindles at well below their rated power, so you can get away without much to cool it....

There is a nice thread on the 2.2Kw spindles here if you havnt seen it yet: The 2.2Kw Chinese Spindles - Info, Setup and Advice + More

.Me

Yep that looks good. Mk10? so you have only just started then:friendly_wink:

I would increase the distance between the y axis rails to match the z axis plate to increase bending and torsional...