Search:

http://www.readresearch.co.uk/personal/mycncuk/x_tuning.png

http://www.readresearch.co.uk/personal/mycncuk/y_tuning.png

http://www.readresearch.co.uk/personal/mycncuk/z_tuning.png

Also, in...

I'll post up my settings later, they are a bit different from what was in the instructions files. TBH I don't fully trust the instructions. Maybe you are losing steps due to bad settings.

Check your pulse train speed as I had a sort of similar issue and found I was running too fast. If you want to post up your axis settings I'll check them against mine. I've got a 3020, but I think...

Just measured my spindle and I've got 4.4 ohms between phases. When driven by AC or pulses the impedance seen is higher because of the inductance, so you can't just use simple ohms law to work out...

It's easier than you think. There were basically two machines, the 3020 type with moving gantry and the sable type with moving table. I chose the 3020 type as it took up less desk space and a...