Search:

I've not had any response from the gentleman Lee.

I'm not in his neck of the woods but I can probably do what he needs.

It doesn't look like he's logged in since he made the post

lower the rpm or increase feed. The problem you are having is heat generation so you need to remove that heat, The main way to do this is by removing a large amount of material that carries the...

Why don't you speak with XYZ machine tools? I understand their support is very good.

Unfortunately a chop saw is only as good as the idiot in control of it... this applies to all machines unfortunately. To a general company that will be about right squareness and length wise......

I misread the original post and as Neal said expressing it as 5000 of an inch is misleading. That interference is fine if it's measured correctly. It needs to be pressed on squarely using tallow....

It's obvious is mm Min. How can it be 117 meters a min? The fastest rapids out there are in the region of 60 mtrs a min. Even if it was inches it would be nearly 3 mtrs a min, Its obvious its not...

Ross, I need to eat a bit of humble pie in a way. I have both tapers at my works and tested your idea. Much to my surprise the actual taper appears to be the same and the and it fits in a R8, and...

Personally i would look at away to mill it if possible. Reason is: its hard to define how that clamp was manufactured in the first place. There is a chance it could drop forged and if it is, it...

There inst an issue with a supplier sending a bit of material that marked up providing they inform you first so you can say 'yea or nay' to accepting it. Tooling plate is after all exactly that 'for...