Search:

Hi all

I have 12, 14 pin 24 volt relays and bases.
These were removed from a decommissioned piece
of kit and only one set of contacts used.
If these are any good to anyone if you pay the...

I have a spare one Chaz if it works ok we can sort something out.

We use them at wok and they are built very well.

Andy

Hi

If the unit is secondhand I would disconnect the motor from the output terminals,the relay you can hear might be an overload circuit which may prevent the unit from powering up.

Do you have...

No don't be daft it my identical brother!

I'm at Junc 28 so not far away, don't mind nipping over and having a look sometime.
PM me your phone number I will give you a ring to arrange a time.

Andy

Hi Chris

You can copy your profile XML file over from your old PC to your new one, but you still might have to retune your motors.

Andy

Hi Colin

That is correct 3phase 240v out.

Andy

Colin

You do not get the collets or let me say I didn't and I don't think anyone else that I know did, I purchased my collets from a Chinese supplier and they have been fine, I have done a couple...

Hi
Just as a comparison have a look at these:-

http://cgi.ebay.co.uk/3-RM1605-637-1137-1137mm-ballscrews-3-sets-BK-BF12-/250543340577?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item3a558bfc21

A...

Hi Tim

Is this what you are looking for?
...

Hi Rob

Home switches are useful for repeatability if you want to use the center of the table you will use one of the offsets in Mach, G54 onwards I think they are, so you could set up a fixture in...

Here's the first video, all its doing here is engraving MDF with a Router V bit.

The spindle is running at 12000 RPM not sure what the feedrate was I was to busy watching what the spindle was...

Hi All

Well I have had my upgraded (I think) machine running tonight,it's been a long time happening :eek:

Some photo's just to show what I have been up to.

1: Showing the new water cooled...