Threaded View
-
06-09-2013 #1
I am putting together a cnc based guitar pickup winder and need some help with power. The winder has 2 stepper motors - one rated at 3.4v / 1.68a and the other at 2.8v / 1.68a
How do I power these motors? Do I need 2 power supply's for the different voltages?
Also any recommendations on good, cheap, easy to set up drives and breakout board would be appreciated.
As you can tell, I am very new at this. If this project goes well I am going to build a cnc for guitar body's and necks.
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
ebay power supply
By irving2008 in forum General ElectronicsReplies: 91Last Post: 29-04-2012, 06:28 PM -
Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
By LoveLearn in forum General ElectronicsReplies: 0Last Post: 25-01-2012, 09:29 PM -
FOR SALE: 50V 20A Power supply
By Jimmybristol in forum Items For SaleReplies: 8Last Post: 30-05-2011, 11:01 PM -
power supply problms
By Scott in forum General ElectronicsReplies: 13Last Post: 11-07-2010, 12:58 PM -
power supply
By hitmythumb in forum General ElectronicsReplies: 6Last Post: 21-06-2009, 10:27 AM
Bookmarks