Threaded View
-
12-12-2015 #6
Last Activity: 2 Hours Ago
If you are mainly cutting wood the screws would be better with X and Y with 10mm pitch and 5mm pitch for Z.
The PLC-4X-g2 I don't think is a motion controller it is a BOB so has to run from the PP. or buy the matching motion controller as well to run it from the Ethernet port. Or look at the smoothstepper card.
Check the inductance on the motors before buying. Good one can be got from https://www.cnc4you.co.uk/Stepper-Mo...s/Nema23-3.1Nm.
In fact don't buy any electronics until you have the final design done and built.
I think you will also need some diagonal bracing on the frame.
Good luck with the build.Last edited by Clive S; 12-12-2015 at 07:32 PM.
..Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WANTED: 150mm dia x 15mm wall Ali pipe
By r0bsk1 in forum Items WantedReplies: 9Last Post: 12-06-2014, 04:19 PM -
Melbourne Andy CNC 1220x810 working area
By AndyGuid in forum Gantry/Router Machines & BuildingReplies: 0Last Post: 17-04-2014, 11:41 AM -
WANTED: Profile rails, 600mm and 900mm
By Jonathan in forum Items WantedReplies: 2Last Post: 16-08-2011, 09:18 AM -
Stick with Ali profile or venture into plate?
By ecat in forum Metalwork DiscussionReplies: 14Last Post: 22-08-2010, 09:00 PM -
BUILD LOG: Newbie First Build 3000mm x 1500mm
By psiron in forum DIY Router Build LogsReplies: 16Last Post: 16-07-2010, 11:02 AM
Bookmarks