. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-05-2016 #3
    lucan07's Avatar
    Lives in northampton, United Kingdom.
    lucan07
    Last Activity: 11-10-2020 Has been a member for 8-9 years. Has a total post count of 257. Received thanks 24 times, giving thanks to others 6 times.
    Look below it says in package "1 x 4 Axis USBCNC 2.1 Substitute MACH3 Interface Board"

    If it does not have plugin its not as advertised and easily returned at their expense for full refund.
    Last edited by lucan07; 09-05-2016 at 09:36 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Lathe suggestions?
    By routercnc in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 71
    Last Post: 29-12-2023, 11:15 AM
  2. Backlash , Any suggestions ?
    By philgiggins in forum Linear & Rotary Motion
    Replies: 18
    Last Post: 13-10-2015, 07:31 PM
  3. Boring Bar Suggestions?
    By Washout in forum Lathes, Lathe Rebuilding & Conversions
    Replies: 10
    Last Post: 21-06-2014, 08:59 AM
  4. Driver suggestions
    By Shinobiwan in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 04-03-2012, 03:54 PM
  5. PLC/Programmable chip suggestions
    By m_c in forum General Electronics
    Replies: 9
    Last Post: 02-04-2011, 04:40 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules