Some Gcode generating programs

[Mad Professor]

Looks like a very handy and quick program to use.

But could you also please add, Plunge Rate, and Spindle speed.

Best Regards.

[M250cnc]

For those Mach3 users not aware Mach3 does have a hell of a lot of wizards built in.

Jonathan not dissing your efforts maybe you would be better writing wizards that are not available built in, no need to waste time reinventing the wheel.

Phil

[Jonathan]

Looks like a very handy and quick program to use.

But could you also please add, Plunge Rate, and Spindle speed.

The feed rate it prompts for applies to plunging. I'll add the spindle stuff in a few minutes.

Jonathan not dissing your efforts maybe you would be better writing wizards that are not available built in, no need to waste time reinventing the wheel.

I didn't realise that there was a similar wizard in Mach3 until after I'd written this program!

Can you think of anything that's not already in Mach3 that you would like?

[RedDan]

The feed rate it prompts for applies to plunging. I'll add the spindle
Can you think of anything that's not already in Mach3 that you would like?

Hi Jonathan,

One change or add on that I am keen to get for mach 3 is the ability to centre text. The current wizard has all kinds of fonts and settings which is great but lacks the ability to centre/resize text to a given size box.

I want to use Mach 3 for more engraving and this is holding me back. Would this be possible?

Dan