. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 11-08-2019 #2
    john swift's Avatar
    Lives in merseyside, United Kingdom.
    john swift
    Last Activity: 18-01-2021 Has been a member for 6-7 years. Has a total post count of 257. Received thanks 53 times, giving thanks to others 0 times.
    Does the other outputs work as expected ?

    Assuming the output transtor is open drain and grounds the relay coil terminal to switch the relay on

    With the power off you can use a multimeter to check the resistance between the negative supply terminal and each isolated output

    in the manual
    http://www.cncdrive.com/downloads/AXBB_E_manual.pdf
    see diagram 9.1.2 .Connecting a solid state relay (SSR)

    test between 24V0 and Ox

    You should find they are all open circuit unless the transistor controlling the relay is short circuited

    John
    Last edited by john swift; 11-08-2019 at 08:22 PM. Reason: correct typo
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Advice on a charge controller please :)
    By blackburn mark in forum General Electronics
    Replies: 23
    Last Post: 04-05-2020, 07:28 PM
  2. CNCDrive AXBB super deal?
    By driftspin in forum CNCdrive (UC100, UC300ETH)
    Replies: 18
    Last Post: 16-03-2019, 10:10 PM
  3. Not sure where the fault lays
    By terry1956 in forum Vectric
    Replies: 5
    Last Post: 20-02-2019, 11:28 AM
  4. fault testing
    By Palletlad in forum General Computing
    Replies: 2
    Last Post: 09-02-2018, 05:51 PM
  5. Jun-Air Compressor Fault
    By jamesgates1000 in forum General Discussion
    Replies: 5
    Last Post: 02-12-2017, 07:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules