Search:

Hi,

There is no need to go back to amana tools for the shape. The angle is correct for cutting length. I checked it. its very easy in fact. In Aspire introduce B of tool as cut depth and change...

Go back to Amana Tools and get the profile DXF use that to select the profile of the cutter you want to use and it sets it up in the toolbase as a tapered tool enter the settings and save.

PM me...

Toby I think you may have a few problems with the machine it sounds like resonance I don't know if you have rack & pinion or what.. What rapid speeds do you get out of it? It seems to be running...

Well you don't say what machine or what you want to cut but some of the setting are wrong ie your pass depth you have set to 1.5" the data sheet says 0.25" roughing.
The feed rate and plunge rate...

You could have two issues working together here.?

First one is that your in Exact stop mode. This is easy to tell by looking at the top bar to see if G61 also on lower right if CV button is Off...

Run wire from the FWD to the Relay Output on the Bob and back to Gnd on VFD. Then Set PN04 = 2. This will take care of ON/OFF provided you Enable the output in mach3 and assign the output number in...

Ok well in this case your massively setup wrong and will be most of your prolem. Also given the nature of how each axis uses gears etc then there's a better way to find the Steps per setting.
...

Most of your trouble is coming from the poor mechanical setup of the machine. The Motor for instance on the Gantry being fastend with just 2 bolts and washers will have massive affect on how they...