Search:

No brainer then get the IP-M.!!

The Csmio-Ip-M isn't ideal for slaved motors as it will only home to one switch not two.
It's a great controller(I use one) and IMO the Cslabs stuff are best by some margin but the IP-M as only...

I think youi should forget Mach4 for now, Mach3 is the one you want.

HTD 5 15mm width are the ones you want and the belts dont need to be steel banded they will be fine fibregalss. Just buy a decent quality branded belt like Dunlop or Gates etc.

Doesn't need anything too fancy Just make a strong frame which fastens to main frame and sit bed on it then surround bed with sealed sides and it won't be any issue but just hanging the bed inside...

Yes they are very accurate see the vid I made.


http://www.youtube.com/watch?v=A11Zvi3nAFE&list=UUBYXm0M-0sgBQmxoJMvE40A



Well if it's just box to contain coolant then yes will be fine but...

Stick with Z0 don't need higher preload than this. The HGH20CAZOC are normal grade bearings and will be fine.

He can shim the Profile between the box section. This will work well and be easy enough to get on same plane with careful setup.

Trev. Design looks ok but I'd build the frame differant regards how...

Well if you haven't bought them already this is worth re-thinking. Profiled linear rails from china are now quite cheap and the difference isn't worth not using them.


Well this again is worth...