Search:

Hi,

I have done some aluminium work with the machine. I will put a photo up of a gear I cut out when I get the chance.

Here is a video of it cutting alloy. This is when the z axis wasn't fully...

Nope it sticks to duct tape. Well mine did at least.

And you would want to remove it. After you take the tape off you can be left with some seriously sharp edges. Just get a sanding disk on a...

Yes that's the link.
Might take you a few shots to get it working well.
A few tips
Make centre distance between holes about 0.4mm bigger or more than hole size.
Set z retract limit quite low, I...

Hi,
I used a 85 degree 2 flute v cutter. The holes are all the same distance apart centre to centre however there size changes according to depth(deeper equals larger). I'll put up a link to the...