Ok, I'm stumped. Question for Gary (ZAPP)

[Gary]

I think as been mentioned pins are assigned as inputs or outputs.
I also think this is in hardware? so i dont think it can be changed.
There is nothing that can be done with the BOB.

Sorry

Hi all,

Ok, I'm hoping that Gary from Zapp will be able to answer this question......

As part of Zapp's driver kit1 you get a very simple breakout board. I never used it as I had an Optoport from DIYCNC. Now, I'd like to use it to build a control panel with various switches etc. but no matter how hard I try, the only pins I can get to be detected as inputs are pins 10,11,12,13,15. I've set Mach up to use pins 2-9 as input but they are not detected at all. Is there something special I have to do on this board to get the outputs to be inputs?

Regards, Jeff.