Thread: Jcb's Quad copter Project,
Hybrid View
-
28-03-2013 #1
Thanks for the heads up on that! I just bought one with the D lense. I also bought a 500mw transmitter so now I have a few weeks to get good at flying!
I also bought 3 spare motors and I should probably buy a few more props to destroy.
I'm using the 4.7 firmware from here and the motors were setup in the correct config. :S
-
28-03-2013 #2
Did you find out what caused the Yaw?? I suspect it was just a balance thing..
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
29-03-2013 #3
no idea, I might just try flipping the yaw gryo and see if that helps.
it really was a spinning death trap when it took off!
could anyone on here help me with my multi-wii board? I've never used anything like it before and don't want to mess it up. documentation on my exact board isn't exactly easy to find either :(
-
29-03-2013 #4
I dont have the multiwii, i have the APM2 but the yawing sounds like you have a motor reversed. Have you checked them?
-
29-03-2013 #5
all the props were in the correct place, maybe one motor had the prop facing the correct way but the motor spinning the opposite way. but it did fly level and I imagine it wouldn't if a prop was forcing air in the wrong direction.
So i conclude that it must be a gyro thing.
-
29-03-2013 #6
Yep if you get an upward thrust of air it'll instantly want to flip on take off as that corner is forced in to the ground where as the other 3 want to lift.
Do you have a magnetometer? That can cause yawing if not calibrated.
-
29-03-2013 #7
no I don't think so, I'm currently using a simple kk 5.5 blackboard.
-
29-03-2013 #8
If you struggle for battery life or weight they are easy to hack to run off your main battery, loads of vids/demos of how to do it floating around. The eletop guys even stuck a battery connector in there in response to complaints about having to solder a couple of wires to hack a new power supply in. Good attitude from a hardware company. :)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Homemade CNC Project Help
By chaslam07 in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 04-04-2012, 11:53 AM -
RFQ: Small CNC Project
By flipflop in forum Projects, Jobs & RequestsReplies: 1Last Post: 20-09-2011, 10:41 PM -
Project IceMould.
By NC-Joey in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 11-08-2007, 07:00 PM
Bookmarks