Mach 3 Driver test results & improvement

[Joe]

Thanks for the reply's

I think I am set on getting a smooth stepper, they are so much better than a PP your right

but I was just wondering if there was any simple fixes that would improve my PC in the mean time but I think I am at the end of the road with this one

Jazz thank you for this kind offer, I am just trying to get things ready for a new machine I am building so there is no rush at the moment but thanks a lot.

A little bit about the machine: Rm1605 ball screws with direct drive

Wantai DQ890MA stepper drives running at 72V

Nema 23 motors

I am basically trying to get the best speed and accuracy I can from this configuration so I think a smooth stepper will be a good addition

Joe