help with servo motors Please.

[ramsbury]

THat is a Very big thank you,
its something Ive been struggling with because these manufacturers are from China and I took the Dims and speeds directly from their machine sites.

Just been convinced to go with Steppers.

[JAZZCNC]

THat is a Very big thank you,
its something Ive been struggling with because these manufacturers are from China and I took the Dims and speeds directly from their machine sites.

Just been convinced to go with Steppers.

Your welcome and please Don't get me wrong I'm not saying Steppers are better than Servo's as they clearly are not, but I am saying in this case I don't think Servo's will be the best for this machine given it's task.

I'm sure the cutting Feeds you mentioned will be un-obtainable in stone without a very very Expensive and powerful spindle which makes the the Whole Servo/Stepper debate mute unless your prepared to part with 3-5K for just a spindle.!!

In Semi Industrial/DIY use then Steppers will more than match the rest of the machine.