Threaded View
-
20-02-2014 #3
Last Activity: 09-07-2024
you mean the bare exposed psu terminals will interfere with the break out board?
what i had planned on doing was unsheathing the main cables as they come in and running them around the bottom and up to the drives - the connections are all good as I have tested it all, just as yet not on the machine.
the break out board will float above the psu.
I flipping layed it all out like that before I bought the box, thinking that will be ok, as the drives are double sided taped to the box for heat sink? soak?
and the power inlet and switch were 2 inches from the main connector on the psu, so there was no mains wire run.
cock - bigger box or see how it goes?Last edited by nobby; 20-02-2014 at 11:25 PM.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Initial thoughts on new build
By Neale in forum Gantry/Router Machines & BuildingReplies: 4Last Post: 25-01-2014, 11:05 PM -
leadscrew conversion thoughts
By GEOFFREY in forum Lead Screws, Nuts & SupportsReplies: 21Last Post: 18-12-2012, 12:56 AM -
Spindle chat and thoughts
By black5f in forum Spindles & Drive MotorsReplies: 4Last Post: 22-11-2011, 10:47 PM -
Some thoughts on using supported rail
By Ross77 in forum Rails, Guideways & BearingsReplies: 0Last Post: 29-01-2010, 07:13 PM -
Any thoughts on pendants?
By Robin Hewitt in forum Machine DiscussionReplies: 5Last Post: 27-12-2009, 07:28 PM
Bookmarks