Mach3 G76 head scratcher

[GeoffV]

Jazzcnc et al

Thanks once again for helping man the pumps, problem resolved but not completely understood.

After much installing uninstalling etc. etc. I took another look at the spindle setup and unchecked the "use spindle feedback in sync mode" this cured the problem running under XP pro and G76 emulation now works correctly. What I don't understand is, with this box checked the simulation works just fine on my laptop running windows7.

It's all PFM!

GeoffV

[JAZZCNC]

Jazzcnc et al

Thanks once again for helping man the pumps, problem resolved but not completely understood.

Makes complete sense really after reading M_C post. Mach didn't see a signal so didn't sync so didn't continue.

Why Win7 worked could be down to not having the PP driver installed.? But i'm guessing. Or it could have had the Index input active other way around.?

Anyway I've got to ask this because my limited brain power can't figure it out.? . . Whats "PFM".?

[Clive S]

Anyway I've got to ask this because my limited brain power can't figure it out.? . . Whats "PFM".?

Urban Dictionary: PFM Technology ..Clive