Extending CY cable?

[Dwayne Dibbley]

Thanks, any tips on joining the shield to keep the shielding continuous and still a shield?

Thanks again

[Rich]

I was wondering (not a recommendation) about heat shrink solder connectors, a foil wrap and ordinary heat shrink as a cover.

[JAZZCNC]

Thanks, any tips on joining the shield to keep the shielding continuous and still a shield?

Thanks again

Just solder together or connect with short piece of wire and Shrink wrap over top.!

[Dwayne Dibbley]

Just solder together or connect with short piece of wire and Shrink wrap over top.!

cool so the shield is still effective over the join even though its not wrapped completely round the cables.

thanks for the tip regarding the staggering of the joints :)

[Jonathan]

cool so the shield is still effective over the join even though its not wrapped completely round the cables.

No it's not effective at all over the join ... but it's not like anyone going to test your machine for EMI anyway, so who cares.

[JAZZCNC]

cool so the shield is still effective over the join even though its not wrapped completely round the cables.

thanks for the tip regarding the staggering of the joints :)

Not really what you'd call effective shielding at the joint but it keeps continuity to ground so any shielding losses are pretty irrelivant at DIY level.

Edit: Didn't see Jon posts which says it all really.

[Dwayne Dibbley]

thanks for the reply's, off to to garage for some lead free fun.