Search:

lcd can go anyway u like
correct plasma are a no no
led lcd fine also
hope this helps

Hi Steve

How did you get on with the normal bearings? I was looking at the 61908 (45x68x12) or the 61809 (45x58x7) as I was hoping the balls where smaller, which is better for high speed...

I have left the direction pulse width at 1, shall I increase that to something similar to the step width to keep the 2 the same?

John, you are right about the screwdriver, had to modify the...

Been playing with the Spindle2 board today and have interfaced it with my controller, got it all working but I have got a little bit of discrepancy with the volts coming out of it and the programmed...

Just ran the spindle again and still not happy with it.....

The problem bearings at the moment are 2 x 16004's - dimensions OD 42mm x ID 30mm x width 8mm

Decided to change them for some 6004's...

Spent another few hours at my DC motor spindle upgrade tonight and I think another couple of hours should see it mounted on the machine and ready to go.

I removed my Z axis from my machine and...

Well, if you place any financial value on your own tiime, I'd say I wasted the most money on leadscrews - being a cheapskate (who was inspired by the easy cnc mill seen on youtube), I went with...

Most worry about building the machine first before the furnishings (steppers, drivers, bearings). Wood, steel and aluminium is cheap in comparison to the trinkets.....Biggest cost i would say is...