Finding center of box

[magicniner]

Jog over the box, and down into it.
Check the box to zero the X and Y coordinates.
Press the X Pocket button.
When it stops, press the Y Pocket button.
Done

What kind of probe does that need for a plastic box?

[dfox1787]

What kind of probe does that need for a plastic box?

Fair point. I think I'll have to maybe stand my edge finder up and quickly move it as it probes......

Sent from my SM-N910F using Tapatalk

[Ger21]

What kind of probe does that need for a plastic box?

You'd need to use an actual probe, rather than the tool and a conductive plate.

But you could use the touch plate, and manually move it from side to side if you are quick enough.

[dfox1787]

You'd need to use an actual probe, rather than the tool and a conductive plate.

But you could use the touch plate, and manually move it from side to side if you are quick enough.

Impressed with the screen set. I just used a old tool and stood my probe plate vetical against the side of the box and probed z and y. Worked a treat..

Sent from my SM-N910F using Tapatalk

[Ger21]

That's what I do, although I've never probed a pocket.
If you use the plate to find an edge, make sure you enter the plate thickness in the Plate Offset box, and the tool diameter in the Probe Diameter box.