Mach3 and USB to cnc driver

[needleworks]

When you say Mach3 and usb to cnc, do you mean you have a UC 100 ? This would replace the parallel port connection. If this is indeed the case, you will find what you need here :- http://cncdrive.com/UC100.html

If not the UC 100, then you would need to explain in more detail.

[Silver]

Thanks for the reply. @needleworks

When you say Mach3 and usb to cnc, do you mean you have a UC 100 ?

I really don't know what it is, it doesn't have any writing if details on it.. it's a plug that fits in to the printer port on the board and has a USB port on the other end to allow me to plug a USB lead in to it.

If not the UC 100, then you would need to explain in more detail.

I have a picture in Jpeg but it won't allow me to upload it for some reason.. picture paints a 1,000 words. So to speak..

Just clicked the link, it does look similar but it's all steel and has a micro USB plug on the input end..

[Silver]

Picture of the adaptor and box.


Picture of message on device driver..

[needleworks]

Sorry mate, I can't help you with that one A quick google search has turned up this page though :- https://sites.google.com/site/usbres...all-usb-driver

Please don't take this as the correct driver for your controller, but it may help you a little. I'm sure one of the guys on here will be able to advise you better.

[Silver]

Sorry mate, I can't help you with that one A quick google search has turned up this page though :- https://sites.google.com/site/usbres...all-usb-driver

Please don't take this as the correct driver for your controller, but it may help you a little. I'm sure one of the guys on here will be able to advise you better.

Thanks for the reply, I had seen that in my searches.

However it refers to putting my disk in to upload the driver.. the disk I don't have I'm afraid.. so was hoping someone on here has had a similar request..

The guy I brought it off is away on Holiday currently so can't get anything resolved there..

May have to wait until he is back to get it resolved.

Thanks again, but if anyone else has any advice greatfully received.

[Ger21]

Throw that USB controller away and buy one that's not made in China, like the UC100. http://www.cncdrive.com/UC100.html

[Silver]

Throw that USB controller away and buy one that's not made in China, like the UC100. http://www.cncdrive.com/UC100.html

Oh, OK.
I didn't know it was from China.

But I understand that the UC100 is made in china as well..

Rather than spending. £100 on a USB converter I may as well put that towards upgrading the board and installing something with a Grbl or smoothie firmware then in that case surely.

That way it will be more up to date and current rather than dealing with an obsolete board! Am I thinking right here?

But didn't want to get in to that straightaway as I haven't dealt with cnc router for some years but I do know gcode and use that on my C02 laser..

Just asked the question of driver if anyone knew of a solution that I believe was the quickest. But may have to wait for the guy I brought it off to get back.