Lichuan "Easy Servo" closed loop stepper question

[Voicecoil]

http://www.t2cnc.hu/downloads/Lichua...r%20Manual.pdf suggests the output is simply the C/E of an optocoupler. Without knowledge of the part number of the opto you could make an educated guess based on common devices - most seem to have a Vceo of 60V upwards.

...of course you could always take one apart to check?

Looking inside I can see a little white (hence likely an opto) 4 pin device adjacent the pins, but like most SMD's it doesn't have the device number, just some cryptic code on it

24V/20ma is a good guess, but there's still the issue of what does it indicate....

[m_c]

Looking inside I can see a little white (hence likely an opto) 4 pin device adjacent the pins, but like most SMD's it doesn't have the device number, just some cryptic code on it

24V/20ma is a good guess, but there's still the issue of what does it indicate....

Something wrong?

I'd guess it'll depend on all what the driver is capable off, and what settings can be changed via software.
Motor/wiring problem (does the drive sense motor wiring issues?), motor following error (there's a parameter for it...).
Have you got a copy of the 'simple commissioning manual' that's mentioned below the parameter table?

[Voicecoil]

Something wrong?

Have you got a copy of the 'simple commissioning manual' that's mentioned below the parameter table?

No, sadly not, all that came with the parts is the manual Doddy put up the link to. I've tried emailing them again, but this time it bounced straight back - I wonder if they've gone under? - though their website is still up and running.

[the great waldo]

I don`t know if this will help, it's a link to their product page
http://servo.xlichuan.com/prod_view....77&FId=t3:69:3

Cheers
Andrew

[Voicecoil]

Well, by chance I came across this page:
https://www.omc-stepperonline.com/cl...tor-cl57t.html
These drivers seem to be mechanically and electrically identical to the LIchuan parts other than the paint colour, branding and slightly smaller supply voltage range - if anyone has one of these it would be interesting to remove the cover and compare the PCB with the Lichuan part, I have a suspicion that they will be very similar knowing how things happen in China!. And there's a manual full of all sorts of good info you can download, and which has a very interesting typo in the last paragraph of page 5

[the great waldo]

Well, by chance I came across this page:
https://www.omc-stepperonline.com/cl...tor-cl57t.html
These drivers seem to be mechanically and electrically identical to the LIchuan parts other than the paint colour, branding and slightly smaller supply voltage range - if anyone has one of these it would be interesting to remove the cover and compare the PCB with the Lichuan part, I have a suspicion that they will be very similar knowing how things happen in China!. And there's a manual full of all sorts of good info you can download, and which has a very interesting typo in the last paragraph of page 5

Hi Voicecoil
The cl57t run with up to 8 amps. I think they are made by leadshine. I have 3 on order at the present time. I'll pop one open when they arrive if it's not to difficult and post a photo.
cheers
Andrew by the way if you order these as kits don't forget they come with cables, I didn't notice that and ordered some cables from their Belgian site. Oh well i'm sure i'll find a use for the wire or plugs

[Voicecoil]

Hi Voicecoil
The cl57t run with up to 8 amps. I think they are made by leadshine. I have 3 on order at the present time. I'll pop one open when they arrive if it's not to difficult and post a photo.
cheers
Andrew

Here's a pic of the Lichuan board.