Looking for someone who can upgrade my 3 axis controller in Berkshire

[joss01]

Thanks that's encouraging will get in contact when I have purchased all the parts. Just one thing can you recommend an upgrade setup not using Mach 3 software?

[JAZZCNC]

Thanks that's encouraging will get in contact when I have purchased all the parts. Just one thing can you recommend an upgrade setup not using Mach 3 software?

If your talking about controller that is stand alone like the Masso then no can't recommend any. If your willing to use a PC then you have several choices but a common one which is good is from CNCDrive either the UC300 or the AXBB-E depending on your needs.

http://cncdrive.com/AXBB.html

[joss01]

If your talking about controller that is stand alone like the Masso then no can't recommend any. If your willing to use a PC then you have several choices but a common one which is good is from CNCDrive either the UC300 or the AXBB-E depending on your needs.

http://cncdrive.com/AXBB.html

[joss01]

I viewed the AXBB and wiring layout looks familiar to my existing controller the use of my CNC is mainly engraving stone it has a waterfeed coolant pump thats controlled from the software. I have never used Mach 3 software so I will have to adapt to using it. I would like to add a pendant controller to the CNC and at the present I have a tool change sensor because the CNC is in damp conditions the sensor occasionally sticks and gives incorrect tool cut depths can is there a unit available that is water proof?