TOS-KURIM CNC Upgrade

[JAZZCNC]

If I did take this route the current setup uses linear scales for position feedback, would that be easy enough to incorporate into this type of system somehow?

I've got a feeling Jamie means the machine is using linear scales rather than encoders for position feedback, which the Anilam Crusader II controller would allow. And wants to know if the scales can be used with the CNCdrive.! Am I correct Jamie.? . . . If not the ignore me and listen to the others because it's correct what they say.!

[JimJam]

I've got a feeling Jamie means the machine is using linear scales rather than encoders for position feedback, which the Anilam Crusader II controller would allow. And wants to know if the scales can be used with the CNCdrive.! Am I correct Jamie.? . . . If not the ignore me and listen to the others because it's correct what they say.!

Yes exactly as you say, sorry I probably didn't explain that very well. I meant that it is currently using linear scales and wasn't sure how it would give positional feedback to the controller if using the CNCdrive muzzer posted without encoders on the motors..

Apologies again for not understanding what's probably the real basics for you guys! Appreciate your patience and sharing your knowledge.