Mach3/Linuxcnc

[jolyonjenkins]

Thanks - I'm away from home at the moment so can't give those details. I think it may even be EMC rather than linuxcnc. TBH I understand so little of Linux (in this case Ubuntu) that I have barely touched the configuration since I bought the whole set-up second hand a few years ago.
What should I be searching for with a BOB?

[Clive S]

Thanks - I'm away from home at the moment so can't give those details. I think it may even be EMC rather than linuxcnc. TBH I understand so little of Linux (in this case Ubuntu) that I have barely touched the configuration since I bought the whole set-up second hand a few years ago.
What should I be searching for with a BOB?

Something like this https://www.ebay.co.uk/itm/5-axis-CN....c100667.m2042