Mach3 lathe spindle pulleys problem

[hanermo2]

Please reply in a civil manner.
You appear as a dick.

If You have factual concerns on anything I wrote, they are quite welcome.

I try to help people who may not have had access to such a wide variety of stuff, so that they can avoid some of the many mistakes I made.
If You don´t like it, You are welcome to leave and be silent.

Do we really need to tolerate Hanermo's fantasy lathe ramblings again?

[m_c]

Please reply in a civil manner.
You appear as a dick.

If You have factual concerns on anything I wrote, they are quite welcome.

I try to help people who may not have had access to such a wide variety of stuff, so that they can avoid some of the many mistakes I made.
If You don´t like it, You are welcome to leave and be silent.

I've been called worse, but at least I actually produce evidence that I have machines, not keep posting the same specs of a wonder lathe nobody has ever seen a single piece of evidence off. How long have you been posting about this wonder lathe? 10 years?
NDA still your stock excuse for the lack of photos?

Anyway moving onto your post, it's maybe factually correct, but if you had read the thread, your commentary is off little or no use to the OP, who understands the limitations of his machine, and was looking for advice regarding pulley ratios, which turns out to be a limitation of the UC100.